Mini Stealth - Orbiter 2.0 v. 1.2.5

Ok, just pulled a sample print off the bed and installed a camera.  Is it just me or is the camera facing away from the nozzle....lol

2 hours ago, Beardo3D said:

Ok, just pulled a sample print off the bed and installed a camera.  Is it just me or is the camera facing away from the nozzle....lol

I don't know why that hole is on the front side of the shroud. It was in the Stealthburner geometry that I borrowed. The camera module should fit the other way around as well.

Ahhhhh...that makes complete sense.  I think the hole just got me thinking down the wrong path.  Thanks for point that out!

I’ve printed the V2 of the mini stealthburner for my Ender 3 pro. I had to modify the carriage to be compatible with my set up. I’ve run into an issue where I don’t have good access to a good x endstop. Does anyone have any suggestions? Thank you 

6 hours ago, loudneon said:

I’ve printed the V2 of the mini stealthburner for my Ender 3 pro. I had to modify the carriage to be compatible with my set up. I’ve run into an issue where I don’t have good access to a good x endstop. Does anyone have any suggestions? Thank you 

I've tried to mock up your setup. It seems to be a decent location for the X endstop. What problem are you having?

3 hours ago, atrushing said:

I've tried to mock up your setup. It seems to be a decent location for the X endstop. What problem are you having?

My EBB36 board is hitting the inside of my z rails before the carriage can hit the x endstop. I did not see any files for a x endstop that can be mounted to the side of the tool head or an extension to make contact with my current endstop location. The picture I’ve attached is as far as my carriage can go before my EBB36 hits my inside z extrusion. 

7 hours ago, loudneon said:

My EBB36 board is hitting the inside of my z rails before the carriage can hit the x endstop. I did not see any files for a x endstop that can be mounted to the side of the tool head or an extension to make contact with my current endstop location. The picture I’ve attached is as far as my carriage can go before my EBB36 hits my inside z extrusion.

Would you be able to add a hole in the side of the x-carriage for an M3 screw? Then you could even adjust the trigger distance.

I have also used the other hole that you can see in the core piece with a heat set insert to add a spacer for sensorless homing  but I don't think it would line up for your printer.