Search the Community
Showing results for tags 'hartk'.
Found 3 results
-
I know I'm a pretty new builder but I've never been quite satisfied with clockwork2, and I am looking for a better solution. I see the LGX lite come up a lot for this and it seems like a pretty solid system. Is there any mounting bracket for stealthburner that will let it use the 2 part hartk PCB? Is there a better extruder option than the LGX lite (and preferably also takes the 2 part hartk PCB)? -
Hello Everyone: I am slowing getting my Voron 2.4r build done and I have entered the wiring phase of the build. I have a Phateus Rapido hot end installed, which according to someone, somewhere, stated that it draws slightly more than 100 watts during startup. I could limit that current draw in the config, but I would prefer not to. I bring this up because the Hartk PCB is rated at 50 watts. In light of this I am running two seperate 20 gauge wires for the hot end which will bypass the PCB's. These two wires will be utilizing the bed output on my Octopus v1.1 board. The question is this... I need 24 volts to the two piece tool head. Where should I get that power from? Would it be from the Octopus or would it be from the 24v power supply. I am assuming it should come from the Octopus, and if so, what output on the Octopus? I would also assume that that 24v should go to the HEO V+ and HEO V- on the Hartk because that is essentially the 24v supply for the head? Yes, when it comes to electronics, I am a noob but learning heaps and enjoying every minute of it. Thank you!
-
