Search the Community
Showing results for tags 'simon2.4'.
-
Version 2.0.0
288 downloads
My printer weighs close to 100lbs and half of that is glass panels. I don't trust current handle designs for that kind of weight but I needed something to make my printer movable. Each one needs 2 screws: 2 x m4-18mm and 2 x m4 t-nuts. The handle is designed to load the extrusions along the inserted ridges. The screws are mostly there to keep it fully inserted; in fact, the handle clips on the frame and hold there without the screws! These handles will make it possible for two people to firmly hold the printer and carry it. STL needs to be mirrored to make a proper pair and 2 pairs needed for a full set. Hinge Clarence: Version 1 installed (v2 looks the same)- 3 comments
-
- 14
-
Version 1.0.0
331 downloads
These are designed to clip into 2020 extrusions and have a 12mm trough to accommodate 11mm LED strips of the most generic kind. a set of 3 is required to cover your horizontal rails. They clip pretty hard. I suggest printing just 1; interrupt the print after the first clip is done and test on your extrusions to make sure it clips but not unreasonably hard. You can use "horizontal expansion" setting in your slicer to adjst the fit. Print them standing up and with a wall width of 0.5mm: this is required for the plastic to comply when pushed in the slot. ** This is meant as a permanent fixture: be careful when testing as I was only able to remove them by sliding off the end. It would suck to have to disassemble your frame ** New shaded version here: Shaded LED rails -
Version 4.2.2022
268 downloads
Two part wire duct that replaces the Z belt covers and directs the wires away from the belts under the deck plate. No need to modify the original deck plate. For easy use, pass wires before assembling with CA glue the upper duct has print support integrated in the part