Search the Community
Showing results for tags 'octoprint'.
Found 3 results
-
I did turn on this thermal runaway plugin for many times. Each time i try it randomly shutdown my mcu. I noticed when Im testing or fixing some issue such as my clogging problem or try to qgl while hot. It mcu shutdown midway. I checked there was not exceed temp. They all on target. Sometime it was on the way cooling down the heat. I dont understand it so I deactivate it so I could continue using my printer without interruption.
-
Klipper doesn't auto write the config after Save_config...
Pradit posted a question in Voron 2 - Questions
Whenever I test something like Z_endstop_calibrate or anything which after the end it mentioned to save_config. And we can expect the auto config in our printer.cfg at the bottom. However, this stop happen to me. I got the PID auto config but that's it. After I did 1st PID and it never write anything for me again. Anything to do with my klipper_firmware_dirty? Please help thanks. -
Hi, trying to get my Voron 2.4R2 to connect to klipper. I have a Raspberry pi 4 model B and an Octopus V1.1 controller board. Getting the following message: Your printer's firmware reported an error. Due to that OctoPrint will disconnect. Reported error: Unable to parse option 'gantry_corners' in section 'quad_gantry_level' I have a 350 x 350 printer and uncommented the 350mm build in the quad_gantry_level of the printer.cfg file. Not sure what I'm doing wrong but it keeps giving me that error even after a restart of the system. Thank you , printer.cfg
