Search the Community

Voron 2.x Skirt Mod for Schaffner FN284-10-06 Overview Voron 2.x skirt mod for the Schaffner FN284-10-06 power entry module with fuse and EMI filter. The Schaffner FN284-10-06 power entry module requires 2 fuses (Ø5 x 20mm) and is rated up to 10 A. There are 3 Faston 6.3 x 0.8mm connectors for spade female connectors or soldering and a 2 pole rocker switch. Description This is an mod for the Voron 2.x skirt You can use two M3x6mm countersunk screws with nuts to mount it on the skirt There are two holes for keystone sockets for LAN and USB on the sides I liked the mod from DC67(../../DC67/plug_panel_schaffner), but could not find the Schaffner FN286-10-06 for a reasonable price. So I designed one for the Schaffner FN284-10-06.

BTT Smart Filament Motion Sensor mounts Overview I always liked the motion sensor on my original Prusa MK3 and was very disappointed when they switched to a mechanical solution that cannot detect motion on the MK3S. So I was pleased to see that Big Tree Tech picked up the idea and even improved the reliability. The MK3 had an optical sensor that tried to detect the filament itself which caused some issues with some type/colour of filament. In the BTT sensor the filament drives a wheel that is then detected by an optical sensor. I did not want to add more weight to my x-carriage, so I designed the mount for the extrusion profiles, outside the printer housing. Description These mounts fit for the BTT Smart Filament Motion Sensor. You can also use two of the housing screws and I have seen other mounts that replace the back of the housing, but I wanted something that is easy to remove, if I have to. You just have to unplug the cable and then the sensor snaps into the mount. To unmount unplug the cable first. I have created two versions to mount the part vertically or horizontally. The installation with BTT SKR boards is easy. The connector already fits to the board connector like the E0 DET. S=Signal, G=Ground(-) and V=Voltage( 3.3-5V) The next step is to configure Klipper. If you use the E0 DET connector then the pin is P1.26 (or xP1.26 if you connected to the x board). It is documented here -

Mounts for Power Terminals from AliExpress Overview I found those no-name power terminals on AliExpress and found them useful to distribute the power in the Voron. So I designed a mixup from the PSU DIN rail mounts for them. !! Use them at your own risk like any other electrical part in your printer. !! Description These mounts fit for the SPL-62 and NC-933 1to3 power terminals that can be found at Electrician Electrical Store on AliExpress. I do like the compact design over the WAGO or Phoenix Contact terminals. They do have a strong clamping force, but I would not trust in the sellers specifications of 32 Amps. For the use in a Voron they should be fine. NC-933 (https://de.aliexpress.com/item/4001236902340.html) SPL-62 (https://de.aliexpress.com/item/4000505115328.html) You can use two M2 self tapping screws to mount them I recommend a stack of washers or a 3D printed spacer for the SPL-62 as the mount holes are not flat on the backside. Again, use them at your own risk. You should not work on mains voltage if you don't know what you're doing. And your printer should be properly protected by fuses, circuit breakers or even a ground fault circuit interrupter. If you have any concerns, don't use them, get genuine WAGO/Phoenix Contact instead!