Search the Community
Showing results for tags 'misumi'.
Found 2 results
-
Version 1.0.0
17 downloads
My designs I have done for high power rocketry bays led me to design connector blocks specialized for that environment. I have taken one of my older designs and remixed it to mount as a right angle four post block for signal and fan wiring. I do like the WAGOs but only for AC/Mains. This block gives you four isolated posts in a space that fits into a extrusion rail with a M3 hammerhead nut. Printed Part 4_post_Wiring_Block_M3_rail Other parts four M3 thermal inserts one M3x12 screw for mounting block one M3 hammerhead T-nut four M3x6 pan head or button head non-oxide screws (shiny) four M3 internal lock washers eight M3 brass washers You can use spade terminals or wrap a loop of wire between the brass washers. Personally, I would use a spade terminal for the controller connection and just strip off the ends of the fan wires, twist them together and wrap it around the post. When a fan goes bad, replacement would be the easist this way. Of note, I have the panels from Printed Solid shown in the picture. The block is only 12mm high, so it can fit against the panel for use in the electronic section.-
- 4
-
-
- eletronics
- mods
- (and 3 more)
-
Hello, New guy here. I would like to build a Voron 2.4 300mm but I'm unsure of how to source the frame parts. Can you source them directly from Masumi in the US? Other than the frame rail sizes, how do you order them drilled and tapped? Any idea of how long it would take to receive the frames? Not in a hurry, just want to plan my purchases. I saw some frame kits on the bay that claim to be original Masumi extrusions shipped from China. Are these an alternative? Unfortunately I'm fussy about quality issues. Regards, Dan
