Search the Community
Showing results for tags 'jgehrig'.
-
Version 2021.09.04
38 downloads
Voron 0 LCD Touchscreen Skirt A large LCD touchscreen for OctoScreen or OctoDash. Bill of Materials All required parts are listed below. Supplier examples are provided for convenience. Non-Printed Parts Additional Non-Stock Parts: Qty Description Supplier Links 1 Adafruit PiTFT Plus 3.2 Touchscreen Adafruit 1 M2.5 x 3.0 mm Heat Set Inserts Alliexpress, McMaster Carr 1 M3 x 50 mm SHCS Alliexpress, Bolt Depot 4 M2.5 x 10 mm BHCS Alliexpress 1 40-pin IDE Extension Cable Amazon Repurposed Stock Parts: Qty Description Supplier Links 12 M3 x 8 mm BHCS Alliexpress, Bolt Depot 12 M3 Makerbeam 1515 T Slot Nuts Alliexpress, Amazon 4 Rubber Feet (14 x 11 x 9) Alliexpress 3D Printed Parts Qty Description STL Slicer Image 2 Skirt Side A 2 Skirt Side B 1 Skirt Front Left 1 Skirt Front Right 1 LCD Mounting Bracket 1 LCD Face Plate 2 Foot Front 2 Foot Rear All 3D Parts can be printed without support material: ABS, 0.4 mm nozzle, and 0.2mm layers. Assembly Instructions Install 4 M2.5 heat set inserts into LCD Mounting Bracket Remove the stock V0 skirt and feet. Install extended feet with 50mm M3 SHCS. Install all Side Skirt A/B parts using the stock mounting T-nuts and M3 x 8 screws. Install the LCD Mounting Bracket using the middle two T-nuts on the front extrusion. Install Front Skirt Left/Right using the remaining two T-nuts on each side of the LCD. Connect the 40-pin ribbon cable to the Adafruit PiTFT Plus. Place the Adafruit PiTFT Plus into the LCD Face Plate. Route the ribbon cable through LCD Mounting Bracket to Raspberry Pi. Secure LCD Face Plate with four M2.5 x 10 screws. Software Configuration Follow the Adafruit LCD Installation Instructions. The 3.2