Search the Community
Showing results for tags 'Kruppes'.
-
Version 2020.10.13
3 downloads
README Overview This is my take on fully enclosing the V0. This mod lifts the printer by 10 mm and requires new legs and skirts to be printed. Without further modification this mod can not be printed on a V0 since a bigger build volume is required. Variants: I designed two variants of the bottom panel: Simple: This only requires a rectangular cut (223 mm x 226 mm x 3 mm) bottom panel (can also be printed). The drawback is that the feet have to be removed to access electronics and the feet can only be properly attached with the panel. Fancy: Requires to cut out to leave out the legs. More loose fit. Non supported corners require stiff panel. Panel can be attached or not independant on the feet. Requirements: Single part skirts (too big to print on V0). Legs matching the variant you chose. 3 mm stiff panel cut to shape. I used Dibond and cut it with a jigsaw. 4 x M3 x 40 mm screws for the longer legs. 4 x M3 x 6 mm screws to mount panel and lip. Lip: The Lip to cover the portion below the spec -
Version 2020.10.13
3 downloads
README Overview Remix of the crew mods deck panel that uses brass heat inserts instead of nylon stand-offs to not have screw heads showing when looking at the printer. Allows inserts 5 mm x 6 mm (shorter 4 mm ones recommended for PSU). Requirements: Designed for spec hardware: PSU: Meanwell LRS-100-24 MCU: BTT SKR Mini E3 1.2 How to print Accent colored Logo The -
Version 2021.01.21
214 downloads
README Overview Inspired by the print in place tension meter Prusa released recently, I drew up this one from scratch. It's not intended to give you an absolute result but I found it accurate enough to measure the same tension independent off the orientation you mount it with. Therefore it should be accurate enough to set multiple belts to the same tension (e.g. V2 z-belts). Print instructions: Only tested with KVP ABS. Always print it with 100% infill Application: The meter has three