-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
QuailMan
Klipper reports: ERROR
Specs: V2.4 running klipper and mainsail. Running a Pi4 and Octopus board. I'm new to this stuff, and not looking for a answer to just be dolled out, but kinda lost at this point.
I had this error congruently, but have since fixed it I believe by removing that line from the mainsail config file.
Source contains parsing errors: '/home/pi/klipper_config/mainsail.cfg' [line 18]: 'CANCEL_PRINT\n' Once the underlying issue is corrected, use the "RESTART" command to reload the config and restart the host software. Printer is halted
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.