Version 2021.12.26
93 downloads
Neopixel Mount
These are neopixel mounts that slide into the V0.1's top extrusions (20 leds in total)
BOM
Neopixel/WS2812B led strip (60 leds/m) only 34cm, 20 leds are needed
Cables
Instructions
Print 4 of the "Neopixel_Mount" (2 for each side)
Solder only the 5V and GND wires on the led strips
Slide them into the mounts
Solder the signal wire based on the diagram below (There is a hole in the mount to allow the wire to go from the one strip to the other)
Remove the 2 screws holding each extrusion into place
Remove the 3 screws that attach the panels onto each extrusion
Slide the mounts onto each extrusion and screw the extrusions in place