-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
Pradit
Im using dupont connector with 2 pin pb8 and ground.
It just hit the back with umbilical wire relief.
And it bend the pin connector off the pin.
My tool head lost control and it hit the bed.
Geez...
Need some help pls share the solution u use with your rear umbilical.
Thanks.
Edited by PraditLink to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.