-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
mortalis
Hi, I have voron 2.4 and I want to configure the SB2040 board. I connected it to the BTT octopus 1.1. For configuration, I used the guide: https://github.com/akhamar/voron_canbus_octopus_sb2040 and official website mellow
I have a problem with the operation of diode (connected to GPIO25), it lights up, the diode reacts to zooming in, but there is no information in the clipper. What I doing wrong?
PRINTER.CFG https://pastebin.com/kqpWu9Nj
Printer.cfg:
No effect for limit switch probe:
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.