-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
mbunjes
Hi, I installed Can on the SB2040, everything reports correctly except for my TAP :
The LED on the tap board is red when down and blue when up. So no issues there.
I soldered the opto-TAP board for 5V and had it originally installed on the 3-pin connector with the 5V and gpio28
I later found out that's not the way to do it and moved signal and ground to gpio25, leaving the 5V as is.
Since it's not working anymore I wondered : did I fry my SB2040 ?
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.