Jump to content

PXL_20240721_232009974.MP

claudermilk

By claudermilk

 Share

Montpelier balloon. 0.25 nozzle, 0.1 layer, painted up. Scaled down to about a good size & fit on the required base size. Entirely printed, including the base and flight stand. The balloon was split into 3 pieces for printing. The center of the balloon is hollowed out with negative spheres in the slicer to save time & material.

This one's gotten particular attention at the local club. One guy has wandered by about 4 times over two gatherings asking to see it again. 😁

From the album:

Miniatures

· 50 images
  • 50 images
  • 8 comments
  • 12 image comments

Photo Information

View photo EXIF information
 Share

Recommended Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
×
  • Create New...