(in)formal introduction

[lawson.brian]

Hello All,

 

Well I thought I better put something here;

Started with a Ender 3 in 2018 - primarily printing TPU for a friend who was helping another guy design Camera quadcopters. That went through a few iterations until it wasn't much of an Ender any more (Duet 2 wifi / Microswiss DD toolhead) but it did print TPU well.

Looked at a better piece of equipment on our return to the UK from kiwi-land and a Voron was mentioned when I started looing at the Ender 5 mercury projects. Found a second hand Switchwire in bits for a bargain price and reassembled her and found out the pain of inductive probes with PRUSA beds and dodgy ABS+ parts.

Started looking for a 2.4 and found a LDO kit a guy had purchased and never unpacked - was looking for a 300 to replace the switchwire and ended up with this 350 at a nice discount. 

The 2.4 is exceptional and the 350mm bed is a dream but still needs some upgrades and the Switchwire is now being rebuilt properly (Still work in progress). I might even get time to grab official serials for them!

And then there is the box turtle project - always did fancy an AMS ........

[mvdveer]

Sounds familiar - Welcome

[PFarm]

Welcome to the forum

[claudermilk]

Welcome to the forum!

[TitusADuxass]

Welcome to the forum.