-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
Xplaner
I'm using an LDO Nitehawk toolboard connected to LDO Leviathan mainboard by USB
1) what entries do I make in the [mcu] section ? Are both the mainboard and nitehawk definitions entered.?
2) what other mods are made to the standard printer.cfg file when using such a toolhead board ?
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.