SuperSlicer Musthave Settings (v2.4)

[Cafe_Delmar]

Hi All!

I saw an emtpy chapter ! wait whaat ? haha, 

Just a burning question to kickoff with...

What would be the musthave settings/changes for a fullyoperational Voron 2.4 with SuperSlicer ?

[claudermilk]

I might start with referencing the Ellis PIF profile: https://github.com/AndrewEllis93/Ellis-PIF-Profile

[Killajoedotcom]

On 3/1/2022 at 8:31 AM, claudermilk said:

I might start with referencing the Ellis PIF profile: https://github.com/AndrewEllis93/Ellis-PIF-Profile

I second this. It's an all in one tuning guide every builder should use to dial in the settings for their individual machine. Yes, they're all Voron 2.4's, but each are hand built and could have some variance here and there. 

As an example, for my Trident, I couldn't use the speeds in the Ellis PIF profile. Something in there caused layer shifting and was really difficult for me to get a nice first layer. I just decided to start from scratch and used the guide to build up my profile rather than tweak an already made one. 

[claudermilk]

He does warn that his speeds are really high and based on his heavily-modded printer. I need to really dig into that profile myself; I have gone through the tuning guide and that got my prints to a good baseline.