Milo V1.5 CNC Bench Mill

[PFarm]

@claudermilk Cutting the 1000mm one to make 1x120mm and 2x320mm. Then one of the 500mm down to 470mm. The 1x250 and 1x500mm are the correct length.

Edited April 5 by PFarm

[PFarm]

If anyone is interested in this tool setter it has two normally closed switches yellow and white switch#1 brown and green is switch#2.

Edited April 7 by PFarm

[PFarm]

I installed most of the heat inserts today, I'd sourced the hardware kit from Aliexpress. It only came with the longer M3 heat inserts the LDO kits have both the short and long ones. The short ones are used for mounting the drag chains, I had the short ones so it wasn't an issue. The T8 bushings for the X backlash are coming with the two 550mm lead screws I ordered.

Note: Installing the M3 insert into the three backlash parts, required drilling the holes with a #17 bit so the M3 heat insert would sit properly. The M3 insert once installed pushes the plastic into the hole of the T8 leadscrew bushing. A 10mm reamer would have been a better tool to clean out the hole but I used a 13/32" bit to get the clearance back.

Hard to see in the photo but the plastic bulges into the T8 bushing hole.

All of the other holes for the heat inserts didn't require drilling to properly install them.

I printed a mount for the 221-413 Wagos this makes the high voltage supply to the VFD neater and simpler. I thought the LDO printed parts guide had the Wago mount listed but couldn't find it. Maybe I was looking in the wrong place.

Edited April 9 by PFarm