TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github

Bigtreetech relay & UPS

By Champ1800
February 19 in General Discussion

Followers 2

Recommended Posts

Champ1800

Posted February 19

- Share

Posted February 19

Hi Folks,

I have a BTT Relay & their 24V UPS but I am having real difficulty finding how to set them up with klipper. I can find Marlin setups alright but that is no use to me.

Has anyone used them? If so could you help out?

Also can the 24VUPS work with XY motors running at 48V.
I was thinking of wiring the UPS to the 24V into the board & the 48V motor power in but to have a diode on the wire from the 48V to the UPS so that the 48V cannot run into the UPS? Would that work?