TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github

Klicky Question

By DIYGuy75
February 4 in General Discussion

Followers 1

Recommended Posts

DIYGuy75

Posted February 4

- Share

Posted February 4

Hello everyone, I am back with another klicky question. You would think that I would have some of this figured out by now.

I did figure out my last klicky issue on my switchwire conversion and I thought putting one on my Ender 5 would be easier since there is no servo to contend with but apparently not for me lol. I have it docking with the macro button but it doesn't move in X to release the klicky. I have the docking move in the variables so I am not sure why it doesn't work. I don't get an error it just docks and stays put.