Hello From England

[Dan_v2.4]

Just discovered the forum whilst searching for mods for my 2.4 (I can't seem to leave it alone). Always looking for ways of learning to make my prints better and my printer for that matter.  I built my 2.4 after upgrading my Ender 3 with a stealth burner and rails enjoyed the way the Voron docs were laid out and decided to pull the trigger on a 2.4 as I'd been eyeing them up for a while   And finally here is my printer in its glory.

[mvdveer]

Welcome to the community. Nice looking printer - traditional colours. Sure you will find plenty of mods around here

[Dan_v2.4]

5 minutes ago, mvdveer said:

Welcome to the community. Nice looking printer - traditional colours. Sure you will find plenty of mods around here

Thanks My kit originally came with red but i wasn`t a fan so reprinted it in pink to be a bit more different than the rest  

[claudermilk]

Welcome to the forum! Can't leave your printer alone? You have found the right community here!