-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
Ran
I'm having an issue getting CAN working. I can see the octopus board on it, but not my BTT SB2240. The resistor jumper is in place, katapult is flashed on the SB2240, klipper in USB-CAN bridge mode is on the octopus, I can see the octopus in the CAN query but that's it. All menuconfig settings triple checked. The CAN cable is good (checked continuity and resistance). I've recrimped the RJ12 connector multiple times, and tried switching the HIGH and LOW wires just in case. What am I missing?
Edited by RanSpelling
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.