-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
polygonprint
Hi all,
Am I correct in understanding, on a 300 x 300 build plate my zero_reference_position should be 150, 150 ?
I perform my z nozzle offset "paper test" at 150, 150 so going by the Klipper documentation the above would be correct ?
Thanks!
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.