Jump to content
  • 0

SB2240 with error: MCU 'EBBCan' shutdown: ADC out of range

KingCrab

Asked by KingCrab,

 Share

Question

KingCrab Newbie

KingCrab

Posted
Posted

Hello,

I just switched from the original setup to CAN with a SB2240, but I'm unable to read the extruder temperature correctly (always -109). I use a 2-wire PT100, my switches are set S1 on, the three others off. This is my config: 

[extruder]
step_pin: EBBCan: PD0
dir_pin: !EBBCan: PD1
enable_pin: !EBBCan: PD2
gear_ratio: 50:10               #BMG Gear Ratio
microsteps: 16
full_steps_per_rotation: 200    #200 for 1.8 degree, 400 for 0.9 degree
rotation_distance: 22.4891434
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: EBBCan: PB13
sensor_type: Generic 3950
sensor_pin: EBBCan: PA3
control: pid
pid_kp: 21.391
pid_ki: 1.240
pid_kd: 92.247
min_temp: 10
max_temp: 280
pressure_advance: 0.02
pressure_advance_smooth_time: 0.01
max_extrude_only_distance: 101

Hope anyone has an idea what I'm doing wrong here?

Thanks in advance

Link to comment
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to question listing

×
×
  • Create New...