-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
Levitron
Hey everyone,
i build up my Voron 2.4 and all works fine for a while. But since last weekend i had the problem that all Status LEDs work fine after booting and during homing egg.. But at the moment when the print starts and the extruder motor is active, all my Hotend Status LEDs begin to flicker.
How can i fix this issue? I use a Stealthburner PCB where all signals come together and are routed to the bigtreetech octopus board via one shielded cable, but no CAN-Bus.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.