Olá from Portugal

[Rachael]

I'm new to 3D printing and am looking into building a Trident - I understand the thermal management is less problematic than the 2.4 which which will allow me to utilize a larger variety of filaments, as I understand it. Looking forward to the adventure.. with some help, no doubt! 

[mvdveer]

Welcome to the forum. I think each machine has it's own challenges. I have two Voron2.4's and one Trident. Printing ABS and ASA on both without warping. Chambers heat to 65 degrees on both the trident and 2.4. I think it is a matter of choice. Please feel free to share your build in a build diary and shout out if you need any help.

[PFarm]

Welcome to the forum!

[claudermilk]

Welcome to the forum! The difference is mainly static bed/moving gantry (V2.4) vs moving bed/static gantry (Trident). The Trident is a bit simpler of a build and the bed being high keeps it in the hot air more in theory.

[Rachael]

"Thanks for the input! I do like the look of the 2.4 a bit more..." she says, as pragmatism slowly slips away.