Jump to content

BTT EBB

McCosch

By McCosch
in General Discussion

 Share

Recommended Posts

McCosch Enthusiast

McCosch

Posted
Posted

Hello community, I modified my Stealthburner and installed a new BTT EBB2209 USB. Now I have a problem where the EBB isn't recognized after every restart. I have to reboot and flash it, and then I can use the printer normally. However, as soon as I restart the printer again, everything is lost. I would really appreciate it if anyone has any ideas.

Link to comment
Share on other sites
polyneutron Enthusiast

polyneutron

Posted
Posted (edited)

Are you using a pi 3 or 4B, or CB1 orCB2 or CM4. I use a CM4 and not every time but way too often it would loose things. Once I shut Klipper down before powering the printer down, nothing would get lost. Recently a SMT clip in fuse to the Nighthawk board blew. Once I replaced the fuse, I had to reinstall everything. On git hub somewhere there is a Klipper shut down app that allows you to shut things down before power is shut off. I hope this helps you, cause it sure fixed my issues.

Edited by polyneutron
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

×
×
  • Create New...