Jump to content

Introduction and Regards

DesP

By DesP
in Introductions

 Share

Recommended Posts

DesP Newbie

DesP

Posted
Posted

Hi All

I have just joined the TeamFDM forum from Perth Western Australia.

I am very much a noobie to 3D printing having just bought a second hand Ender 3.

But, like most things I seem to do, I have done it the hard way. The printer has been flashed with klipper and the control board has been disconnected as it should run using an external SBC.

I am having some issues with my Raspberry Pi and klipper so will post in a more appropriate section of the forum.

So, looking forward to being part of this group.

Regards

DesP

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

×
×
  • Create New...