-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
Virtual_Frippe
Hi
Im new to 3D printing and recently bought a Voron 0.2, i succesfully printed my first print yesterday and today after i changed place of the filament so it wouldnt get tangled up, I got an issue where i got the error message saying that the nozzle dont heat up as expected and suggested restart of firmware. I searched and found out that the most common problem was the wiring. So i checked the cables and the heatprotected 14pin cable running from the printing head had three cables that had loosened from the contact, probably due to strain.
Would you recommend trying to repair the cable? I think it seems a bit shorter than necessary? Or order a new one? If so do anyone know where could i find one?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.