Search the Community
Showing results for tags 'phaetus'.
Found 2 results
-
So I've just been running a long print. Came back to it halfway through to find the following error message on the screen. I have tried reheating the hotend but the temp stays the same and the printer shuts itself down again after a minute or two. I only bought this hotend last week as a replacement for my V6 and can't believe its messed up already. When I was installing this hotend I could find ZERO information about installing it and any firmware changes that were needed, not even from Phaetus. So I carried on using the Generic 3950 for the thermistor and kept every other setting the same. Does the Rapido need specific firmware changes, cause I was searching for ages and couldn't find anything. Is this a common error with this hotend?
-
Version 1.1
409 downloads
This is a modified Stealthburner to fit a Mosquito Magnum hotend with a Phaetus UHF Adapter/nozzle. Fan duct to Nozzle Clearance is 1mm. Included are files for 2 mounting options. and the front cover that will fit. The usual side by side mounting, and the probably not very used at all diagonal mounting. Requires 2 heatset inserts. Then you install the screw from the bottom. Let me know if it works for you, or if it needs adjusting.
