-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
5twenty
Had this hooked up to my StealthBurner and wasn't getting my fans to work, and after a long time trying to trace the issue, I metered the toolhead board specific (SB2040-F) and discovered the 5v/24v rail were shorted! To the point only 5v was going through.
The actual board is good, the only issue is the part that goes in the face, behind the fan, to connect the fans and LEDs.
I've tried searching the enshittified Google, but....
Anyone know where to get just that triangle shaped board? I'll contact Mellow as well, but I'm sure it was my fault, kind of, since they don't install headers and make you solder your own!
Thanks all.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.