-
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
- 0
TeamFDM.com is an UNOFFICIAL companion site for the DIY Voron 3D printer community. For official docs and final source of truth, visit the Official Voron Discord or the Voron Github
Question
owesto
I have an Ender6 with a creality board 4.3.1 motherboard and orbiter v2 I can get it work any help would be appreciated.
[extruder]
microsteps: 16
full_steps_per_rotation: 200
rotation_distance: 4.637
nozzle_diameter: 0.400 #define nozzle diameter
filament_diameter: 1.750
max_extrude_only_distance: 500
max_extrude_only_velocity: 120
pressure_advance: 0.025 #to be calibrated
pressure_advance_smooth_time: 0.03 #to be calibrated
[tmc2208 extruder]
uart_pin: PE1
interpolate: true
run_current: 0.85 #**
hold_current: 0.100
sense_resistor: 0.11 #**
stealthchop_threshold: 0
driver_TBL: 0
driver_HEND: 6
driver_HSTRT: 7
driver_TOFF: 4
heater_pin: PA1
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PC5 #to be calibrated
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.